WinUAE 4.0.1 erschienen

Gestern erschien eine neue Version des beliebten Amiga-Emulators mit ein paar Bugfixes des letzten großen Updates. Folgende Änderungen wurden vorgenommen:

4.0.0 bugs fixed:

  • Enabled “Minimize when focus is lost” option caused crash in some situations.
  • 64-bit FPU mode always changed back to 80-bit if config file was loaded.
  • 80-bit native FPU mode FREM and FMOD returned wrong results.
  • RTG statefile restore didn’t restore screen state completely.

Other bugs fixed:

  • “Minimize when focus is lost” incorrectly activated when switching modes in some situations.
  • “Minimize when focus is lost” minimized main emulation window when GUI was open and main window lost focus.
  • If CPU panel FPU mode select menu was active and then some other panel was opened: JIT was switched off.
  • CD audio play from real/virtual CD (not from directly mounted image file) didn’t restart correctly if audio settings changed.
  • Only some emulated SCSI controllers flashed CD led when emulating a CD drive.
  • input.keyboard_type was always read as Amiga keyboard. If PC layout was set as default, keyboard layout was read incorrectly from config file.
  • Amiga reset during active RTG rendering in RTG Multithread mode could have caused a crash.
  • RTG Multithread mode display refreshing was unreliable in 8-bit modes when palette changed.
  • Finally fixed corrupted drag and drop graphics in Harddrives and Disk Swapper panel.
  • When inserting previously connected USB input device, previous device type (Gamepad, CD32 pad etc) and autofire mode (if any) was not restored.
  • Clipboard sharing could have attempted to transfer data to Amiga side after program had taken over the system, possibly overwriting memory.

New features:

  • Environmental variables (%variable%) in paths are not anymore resolved immediately when config is loaded but only when needed without modifying original path, preserving original path if config file is saved again.
  • Added full statefile absolute/relative path support. Loading statefile will restore correct paths even if absolute/relative path mode was changed after saving the statefile.
  • D3D9 and D3D11 VSync mode (both lagless and standard) 100/120Hz support with optional black frame insertion.
  • 68060 FPU was not disabled after soft reset if 68060 was configured without emulated 68060 accelerator board, causing reset loop.

New emulated expansions:

  • QuikPak 4060

Die aktuelle Version hier es hier.